Product Characteristics
1. Temperature resistance: Matches the working condition of about 145℃ for belt vulcanization. The rubber compound is heat-resistant and resists rapid aging (but dry burning for a long time is not allowed).
2. Expansion performance: Good ductile expansion. It bulges evenly when pressurized and rebounds after pressure relief.
3. Customizable specifications: Belt width and bevel angles (17°/22°/90° for inclined joints) can be customized according to vulcanizer specifications.
4. Limitations (for reference)
• It is a rubber consumable. Repeated use under high temperature and high pressure will cause aging, bulging and delamination, so it has a limited service life.
• Prone to puncture by sharp hard objects; debris must be cleaned on site.
• Not suitable for ultra-high temperature working conditions without heat insulation protection.
Material: Natural rubber with polyester reinforcement layer
Working pressure: 1.0~2.0 MPa
Medium: Clean water
Hardness: Shore A 60~70
Tensile strength ≥12 MPa
Elongation at break ≥350%
Size: Customized to hot plate dimension
Water inlet: DN15 / DN20 quick connector
Warranty: 12 months
Core Advantages
1. Uniform pressure, no dead pressure zone
Pressure is transmitted by water (fluid). The pressure on the entire contact surface is consistent. Unlike rigid pressure plates, there is no insufficient pressure at the edges and corners. The vulcanized belt joint is flat with few bubbles and debonding, delivering a higher qualified rate of joints.
2. Lightweight for easy on-site handling underground
About 70% lighter than traditional metal hydraulic plates. It is labor-saving to assemble, disassemble and transfer, showing prominent advantages in narrow spaces such as mines and tunnels.
3. Flexible and self-adaptive
It has elastic expansion capacity and can slightly fit minor unevenness on the heating plate and belt surface, offering good fault tolerance. The frame bolts do not require high pre-tightening torque for easy assembly.
4. Compatible media (water and air)
Most models can be pressurized either by water or air. An air pump can be used for emergency when water is unavailable on site for strong adaptability.
5. Stable sealing and leakage resistance
Integrally vulcanized in one piece with few joints. Qualified products can steadily withstand 1.0~2.0 MPa for a long time with stable pressure holding and low risk of water leakage.
6. Simple structure and easy maintenance
No complex oil circuits or steel sealing parts. Only the water bag itself needs to be replaced after damage, with low maintenance cost.






